BMR Suspension TAS011 User Manual

Page 10

(CONTINUED)

48. Mount a Watts link arm onto the

bottom rod end. (Image 24)

NOTE: Some images show Watts link
arms with bends in them. This was a
previous design, all current arms are
equal length, straight arms.

49. Position the other end of the Watts

link arm into the drivers’ frame
mount. Position it in the mounting
location that places the Watts link
bar as level as possible when the
Watts pivot is vertical (straight up
and down). Insert one of the
provided ½” x 3” bolts. Thread a
stainless washer and nut onto the
exposed threads and leave finger
tight. (Image 25)

50. Duplicate steps 49-50 for the

passenger side Watts link arm.

51. As shown in Image 26, use a

plumb bob to determine proper
axle location. NOTE: it is not
necessary to remove the wheels
and tires to accomplish this, the
measurement can also be taken
from the wheel itself. Hold the
plumb bob against each wheel well
in the same position and measure
the axle location in relation to the
fender. Adjust the rod ends until
each wheel measurement is equal
while the Watts link pivot remains
vertical (not angled).