Brewer Access High-Low - Manual (Page 8)

Document # 100452 RevL 8 Printed in USA © 2013
WARNING
Keep personnel and equipment clear of table be-
fore initiating movement to avoid personal injury
or damage to the equipment.
NOTE: The control system is protected by a fuse to
prevent excessive current draw which could damage
the system. If operation does not resume after a cooling
period of one hour, contact your dealer or an authorized
service center for repair.
General
DANGER
Do not use this table in an explosive or oxygen-
rich atmosphere. To do so will result in an explo-
sion or fire.
WARNING
If the table malfunctions, immediately remove your
foot from the controls, unplug the power cord from
the electrical receptacle, and assist the patient
from the table. If table continues to malfunction,
call for service. Do not attempt to repair table your-
self.
WARNING
Before initiating power, keep personnel and equip-
ment clear of the table movement to avoid person-
al injury or equipment damage.
OPERATION
CAUTION
The foot control is moisture resistant and runs on
low voltage, eliminating shock hazards. However,
to avoid temporary or permanent damage to the
foot control, do not immerse in water or liquids.
CAUTION
Keep foreign objects away from foot control. To
avoid accidental operation, be sure the foot con-
trol is NOT positioned below the front of the table.
Failure to do so could result in unwanted motion
and possible damage to the table.
NOTE: For optimum table performance, allow the table to
reach room temperature before operating.
NOTE: The table is not designed for continuous opera-
tion. The control system includes a thermal overload
safety switch to protect from overheating. If the table is
operated continuously causing the control to exceed its
allowable operating temperature, the thermal overload
safety switch will shut off. If normal operation ceases,do
not attempt to operate the table. Allow the table to cool
for 10-15 minutes before attempting to use again. The
thermal overload switch will automatically reset when it
has reached a safe operating temperature.
Model Configurations
NOTE: Each control function will automatically stop
moving when either the UP or DOWN travel limit is
reached. If the foot pedal is pressed with travel at its
limit, the actuator will not operate. Sensors prevent the
actuator motor from operating when travel limit has
been reached, preventing wear of the actuator.
Model Power Back Pneumatic
Manual Back
Pelvic Tilt Drawer
Warmer
Return To
Chair
6000 X
6001 X X X
6500 X X
6501 X X X X
6800 X X
6801 X X X X