Brewer Access High-Low - Manual (Page 2)

Document # 100452 RevL 2 Printed in USA © 2013
Service
If you require assistance with the installation or operation
of your Brewer table, call the Brewer Customer Service
Department at (1-888-Brewer1). Our trained staff will
attempt to assist you in correcting the problem directly
over the phone. If service is required, a factory authorized
technician will be sent to your location.
Please fill in the following information for use when calling
the Brewer Company or your distributor with questions
regarding your unit. See Figure 1 for model and serial
number location.
Date of Purchase
Serial Number
Model Number
Authorized
Dealer Name
Dealer
Phone Number
Dealer Address
IMPORTANT INFORMATION
General
The Brewer Access High-Low Exam Table Model 6000
Series is designed to provide positioning and support of
patients during general examinations conducted by quali-
fied medical professionals. Read and understand all op-
erating instructions, safety information, and maintenance
requirements contained in this manual prior to operating
the table. Become familiar with all of the table functions
before using it with a patient.
The Brewer Access High-Low Exam Table is primarily
used in examination rooms for general examinations and
minor procedures. The wide variety of positions provided
by one or two powered motions, slide-out leg support,
slide-out leg extension, stirrups and treatment pan, create
a safe and convenient patient positioning table for most
examinations and procedures performed in the doctor’s
office.
The table is easily adjusted to a wide variety of positions
using the convenient foot control provided with the table.
The table height can be adjusted from 19” to 37”. The
table seating surface on models 6001, 6501, and 6801
can be moved from the normal horizontal position to an
angle of 5°. The backrest can be adjusted from a flat ly-
ing down position, to an 80° angle for seating.
In addition to the electronically controlled positions noted
above, several manual adjustments are available:
• The leg support can be extended 14” for the patient
prone position. If more length is needed, the leg ex-
tension can be pulled out to provide an additional 6”.
• Stirrups may be manually extended through infinite
positions and four lateral positions.
• A removable treatment pan is built-in underneath the
leg extension for use during examinations.
• Grab bars attached to each side of the table may be
rotated out of position or removed for improved ac-
cess to the patient.
• A pass through work surface, stored under the seat,
may be pulled out from either side of the table.
• Storage drawers at the front and side of the table may
be used for supplies. The pass through side drawers
may be pulled out from either side of the table.
• A storage cover at the rear of the table can be lifted to
store paper rolls.
Models 6000, 6001, 6500 and 6501 are designed to
accommodate a maximum patient weight of 450 lbs.
Models 6800 and 6801 are designed to accommodate
a maximum patient weight of 700 lbs. Figure 1. Model and Serial Number Location
Model Number
Serial Number