Brewer Access High-Low - Manual (Page 21)

Document # 100452 RevL 21 Printed in USA © 2013
2.2
a
b
c
d
e
f
Yes No
No Yes
No backrest movement. Motor
hums in the up direction but there
is no movement.
No Yes
Are there other problems not yet
identified?
No Yes
Table does not go all the way
down. After table stops in the down
direction, continue pressing the
down pedal. One actuator
continues to hum for a few seconds
while there is no movement.
Backrest safety switch, 1 or more
of 4 is not closing when pressed.
Press each one and listen for click
when pressed and again when
released. Replace as necessary.
Replace back actuator.
No Yes
One lift actuator has failed.
Replace both lift actuators. Return
to step 1.
Table raises slightly slower than
normal while the up pedal is held.
One actuator continues to hum.
Retun to step 1.
Step 2.2 continue here
Call 1 888-Brewer1 for technical
assistance.
No problem found, test complete.
Table is low and does not rise, but
motors hum when up pedal is
pressed.
Return to step 1
Still bad Fixed
Backrest or table lift stuck in full up
position. No motor hum. Control
box relay clicks in both up and
down direction.
No Yes
6000 SERIES TABLE TROUBLESHOOTING CHART (continued)