HP iPAQ hw6500 Unlocked Mobile Messenger series - Manual (Page 110)

Using the Camera Features 10–7
• 640 x 480 pixels
• 1280 x 960 pixels (default)
Flicker Filter
Fluorescent light bulbs flicker due to the alternating current. The electronic
shutter on the HP iPAQ is not immune to this flickering, though the human
eye is. The Flicker Filter setting is used to filter out the flickering or banding
caused by fluorescent lighting.
To adjust the banding that can be caused by fluorescent lighting, select
from the following settings:
•
Auto (default)—Automatically adjusts the banding on the HP iPAQ
for the best picture.
• 50 Hz—Filter out banding caused by fluorescent light bulbs that
operate on AC at 50Hz
• 60 Hz—Filter out banding caused by fluorescent light bulbs that
operate on AC at 60Hz
Setting Up Other Features
Camera Sounds
Camera Sounds allows you to turn on or off any sounds made when
buttons are pressed.
1.
From camera mode, tap > Setup tab.
2. Tap Camera Sounds, and then tap Change.
3. Tap Off to turn off the sounds, or tap On to turn on the sounds.
4. Tap OK to exit the Settings menu.
Configuring Instant Review
Instant Review allows you to see a preview of the image you just captured
to quickly determine whether you want to keep or discard the image.
To set the time period for Instant Review:
1.
From camera mode, tap > Setup tab.
2. Select Instant Review from the list, and then tap Change.
3. Select the period of time you want the Instant Review image to
remain on the screen.
4. Tap OK to exit the Settings menu.
Using the Self-Timer
The Self-Timer allows you to set a short delay before a photo is snapped.
Use this feature when you want to be in your own photos.
To set the timer:
1.
From camera mode, tap > Setup tab.
2. Select Self-Timer from the list, and then tap Change.