HP Insight Control - Manual (Page 8)

The VM column also displays VME Server status. To navigate to the VME Server credentials user
interface, select Options
→VME Options→View VME Settings.
Table 3 vCenter Server status icons displayed in the VM column
Status Icon
The VME credentials were set. However, currently VMM is not able to connect to the VME Server. The
cause could be either that the VME service is stopped OR the credentials have changed OR the VMM
service is stopped.
The VME Server credentials is set and VMM is able to connect to the VME Server.
To display additional information for the system, click an icon.
When you register the SCVMM server as a Hyper-V host, the behavior of the SCVMM VME status
icon takes precedence over the status of the Hyper-V host so the VM status icon on the SIM page
displays the state of the SCVMM server and not the state of the Hyper-V host. The following table
explains the behavior of the status icons depending on the host set-up.
Table 4 Icon Behavior
VM Status Icon Behavior Host
The icon displayed signifies the status of the VM host. Hyper-V only
The icon displayed signifies the status of the VME server. SCVMM only
The icon displayed signifies the status of the VME server. Both Hyper-V and SCVMM
Agentless management
Insight Control virtual machine management 7.0 or later is completely agentless and no longer
requires deploying an agent to manage the ESX hosts. If you are upgrading an existing version
of virtual machine management, then HP recommends stopping the virtual machine management
agents that were deployed earlier on the ESX hosts from the setup.
NOTE: All templates and backups that were created using previous versions of VMM must be
converted to templates and backups compatible with VMM 7.0 or later. These conversions require
older Insight Control virtual machine management Agents to be running on the managed nodes.
To stop the VMM agents, perform the following steps:
•
Verify whether the hpvmmcntsvc service is running on the ESX host by executing the following
command on the ESX host console: service hpvmmcntsvc status.
•
If the hpvmmcntsvc HP Insight Control virtual machine management service is running, then
stop the service by executing the following command: service hpvmmcntsvc stop.
Setting the correct host name length
The host name must consist only of alphanumeric characters, hyphens, and underscores. The host
name and domain name for Insight Control virtual machine management must not exceed 64
characters for hosts that do not require VMM agents to be installed (ESX4.x/ESXi4.x/Hyper V/ESXi
5.0):
8 Introduction