HP Officejet Pro L7380 All-in-One Printer - Manual (Page 210)

3. Remove the control-panel faceplate as follows:
a. Lift the ADF lid.
b. Use either your finger or insert a thin object in the tab on the upper right corner of the
control-panel faceplate to pry the control-panel faceplate off.
4. Retain the control-panel faceplate. Do not return the control-panel faceplate with the HP All-
in-One.
CAUTION: The replacement device might not come with a control-panel faceplate.
Store your control-panel faceplate in a safe place, and when the replacement device
arrives, reattach your control-panel faceplate. You must attach your control-panel
faceplate to use the control-panel functions on the replacement device.
NOTE: See the setup poster that came with the device for instructions on how to attach
your control-panel faceplate. The replacement device might come with instructions for
setting up your device.
Pack the device
Complete the following steps after you have prepared the device for shipment.
Appendix B
206 Support and warranty