HP NonStop G-Series - Manual (Page 184)

Creates a snapshot of the ServerNet Switch Board's logic board memory. Perform Dump Memory to
dump this snapshot to a file in $SYSTEM.ZSERVICE.
Hard Reset
Resets the ServerNet Switch Board hardware and the routing tables.
ME FPGA Update
Allows you to update the FPGA code file for the Maintenance Entity (ME) of the ServerNet Switch
Board.
ME Firmware Update
Allows you to update the firmware file for the Maintenance Entity (ME) of the ServerNet Switch
Board.
Replace
Launches the guided procedure to replace a ServerNet switch board in an IOAM or processor switch.
Set LED State
Turns the ServerNet Switch Board LED on or off.
Soft Reset
Reinitializes the firmware without affecting the ServerNet Switch Board hardware or the routing
tables.
Service Processor (SP)
Attributes
Actions
The service processor (SP) controls environmental and maintenance functions and acts as the master
of the serial maintenance bus (SMB). The service processor is a physical component of
PMF , PMF2 ,
IOMF , and IOMF2 ) CRUs.
Location in OSM Tree: System > Group > Module > PMF2 > SP
Slot Location: Service processors are located on the PMF CRUs and IOMF CRUs in slots 50 and 55
of processor and I/O enclosures (service side).
Example: SP (1.1.50)