Actions, Fcsa, Attributes – HP NonStop G-Series User Manual
Page 116
Configured Controller
Location
The location of FCSA connected to the disk drive through Port A.
Example: FCSA.FSAC-1.GRP-111.MOD-3.SLOT-1
Fibre Channel Controller
Identifies the FCSA FSAC connected to the FCDM through Port A.
Example: FCSA FSAC (111.3.1.1)
Actions
None.
FCSA
Removing and Installing a Fibre Channel ServerNet Adapter
Fibre Channel ServerNet adapter. The FCSA object always displays two
s, regardless of
whether they are both physically present. At least one must be present to perform FCSA firmware
updates. The FCSA FSAC attributes
FSACs and attached disks. Unlike many other adapters, the ports on the FCSA are numbered from
top down when viewing the FCSA installed in a rack. Thus, FCSA FSAC 1 is attached to the upper
port (port 1) and FCSA FSAC 2 is attached to the lower port (port 2).
Note: If a ServerNet switch board is not present, FCSAs do not appear in OSM.
OSM does not display FCSA attribute information until an associated disk process is configured and
started. For more information, see the Fibre Channel ServerNet Adapter Installation and Support
Guide.
Location in OSM Tree: System > Group > IOAM Enclosure > IOAM > FCSA
Example: FCSA (13.3.1)
Attributes
FCSA
Service State
Displayed in the Attributes tab and Attributes dialog box only if the value is
something other than OK.
Physical
Hardware Revision
A code that identifies the generation of the component. Hardware revision
codes are used for tracking components.
Manufacturer
Identifies the manufacturer of the component.