Options on the discovery page – HP Systems Insight Manager User Manual

Page 38

Physical Servers

This discovery task is for discovery of physical servers (blade servers and standalone servers).
The management processors for these servers must be discovered prior to this discovery task
being run.

Virtual Machines

This discovery task is for discovery of virtual machines associated with servers discovered in
the previous category.

NOTE:

If discovery tasks are run out of order, errors are likely. Typical errors due to running

discovery tasks in an improper order include:

•

Association errors

For example, a server not associated with a management processor or virtual machine not
associated with a virtual machine host.

•

Credentials errors

Because discovery of systems can trigger additional discovery of associated systems or
management processors, if the correct credentials are not supplied for the associated systems,
their discoveries are likely to show errors. If you discover these associated systems with a
subsequent discovery task containing the proper credentials, they should then complete
successfully.

NOTE:

Citrix Xen VMs discovered in category 5 will always return a discovery error unless the

Citrix Xen Host has been registered through Configure

→Virtual Machine→Register Virtual Machine

Host.

If you have a small network, an alternate way of setting up your discovery tasks is to create a
single task with one IP address range and all of the required credentials for the systems in that
range. However, doing this can make it difficult to troubleshoot and diagnose errors if one or more
systems are not configured correctly.

Options on the Discovery page

Under the For all automatic discoveries section, the following options are available:

•

Configure general settings

Select this option to configure general settings that apply to all discovery tasks.

•

Manage hosts files

Select this option to manage

hosts files

•

Configure global protocol settings

Select this option to configure global protocol settings.

NOTE:

To discover clusters correctly, you must enable SNMP with the correct security settings

on HP SIM on the target systems.

From the Discovery page, you can:

•

Create a new discovery task

Click New and the New Discovery section appears.

•

Edit an existing discovery task

Select a task from the table,and click Edit. The Edit Discovery section appears.

Discovery