HP Insight Management-Software - Manual (Page 79)

Table 36 VCEM server error messages and descriptions (continued)
Error message description
NOTE: The error message descriptions in this table use
[x] to represent variables in the error message output. Error message number
Missing base initiator configuration in FC SAN connection
for interconnect bay . 2682
Cannot perform server profile assignment because bay is
an auxiliary server blade. 2683
Cannot assign server profile because the selected bay is
covered. 2684
The slot number associated with node is not valid for a
server blade. Valid numbers are 1 - 16. 2709
Systems Insight Manager did not find an cabinet associated
with node . 2710
Cannot create FC SAN connection because the maximum
number of FC SAN connections was reached. 2717
The operation could not be performed because Server
Profile already contains the maximum number of network
connections. 2718
Cannot remove FC SAN connection because the Server
Profile does not have a FC SAN connection 2719
Cannot remove Multiple Network because the Server Profile
does not have more available Multiple Networks to be
removed. 2720
Could not remove the connection because the port number
was not found. 2721
Could not set the Multiple Network because the given port
was not found. 2722
Only one VNet can be Untagged. 2723
The provided configuration for multiple networks exceeds
the maximum allowed number of VNet mappings. The
maximum number of VNet mappings is 28. 2724
There are duplicated VNet Names. Choose a different one. 2725
The entered VLAN id is not valid. Please enter a valid value
(1-4094) for Server VLan Id. 2726
The vNet name cannot be Unassigned. Select one vNet
name for each mapping. 2728
There are duplicated server VLAN Ids. Type a different
VLAN Id for each mapping. 2729
The provided configuration for multiple networks does not
have the minimal number of VNet mappings. At least one
VNet mapping is required. 2731
There is no VNet selected. Only mappings with a VNet
selected can be marked as untagged 2732
In the FC SAN connection for interconnect bay , the
selected port speed is invalid. Verify that the FC module 2733
of interconnect bay supports the 8Gb downlink speed
value.
79