HP Insight Management-Software - Manual (Page 42)

add iscsi-connection
The -add iscsi-connection command adds a new iSCSI connection to an existing VC server
profile.
NOTE: The -add iscsi-connection command can be executed only if the current VC
domain is managing one or more VC modules that support iSCSI connections.
Syntax
-add iscsi-connection –profilename
[-network ]
[-speedtype ]
[-speed ]
Parameters
Table 17 Parameter descriptions for -add iscsi-connection
Optional Required Description Parameter
x The name of an existing
profile to add the new
connection to. -profilename
x The name of an existing
network to associate with the -network
connection. If the network
name is not specified, the
network is unassigned and
can be assigned later.
x The requested operational
speed for the server port. -speedtype
Valid values include auto,
preferred
and custom.
Default value is preferred
The following list describes
the speed type:
•
Auto—Allocates
maximum port speed
constrained by the
maximum configured
speed for the network
•
Preferred—Speed of the
network matches the
preferred speed of the
network to which the
connection is associated.
NOTE: If no preferred
speed is configured, the
network speed defaults to
auto
.
• Custom—Configures any
speed from 100Mb to the
maximum configured
speed for the network in
100Mb increments.
x
NOTE: The parameter
-speed is required if
-speedtype is set to
custom .
The user-defined speed for
a server port. Valid values
include 100Mb to the
maximum configured speed
for the network in 100Mb
increments. The acceptable -speed
42 Using VCEM commands