HP Insight Management-Software - Manual (Page 47)

set iscsi-boot-param
The -set iscsi-boot-param command configures the basic iSCSI boot parameters on the
specified iSCSI connection.
Syntax
-set iscsi-boot-param
–profilename
-portnumber
-bootorder
[-lun ]
[-initiatorname ]
[-initiatorip ]
[-mask ]
[-gateway ]
[-vlanid ]
[-targetname ]
[-targetip ]
[-targetport ]
[-targetip2 ]
[-targetport2 ]
[-authentication ]
[-username ]
[-secret ]
[-mutualusername ]
[-mutualsecret ]
[-iscsibootparamdhcp ]
[-networkparamdhcp ]
[-dhcpvendorid ]
Parameters
Table 20 Parameter descriptions for -set iscsi-boot-param
Optional Required Description Parameter
x The name of the profile
associated with the
iscsi-boot-param. -profilename
x The number of the port for
this set of parameters. -portnumber
x Enables or disables iSCSI
boot. Selecting primary, -bootorder
secondary or usebios
will result in the iSCSI boot
being enabled. The default
selection for this attribute is
disabled
.
x The Logical Unit Number
(LUN) of the Target identifies -lun
the volume to be accessed.
Valid values for standard
LUNs are 0-255 decimal.
Valid values for extended
LUNs are 13 to 16 character
hexadecimal values. The
default value is zero.
set iscsi-boot-param 47