HP Insight Management-Software User Manual
Page 14
•
Select from the following Flex-10 iSCSI network connection options:
Add Flex-10 iSCSI network connections using the -add iscsi-connection command.
◦
◦
Modify Flex-10 iSCSI network connections using the -set iscsi-connection
command.
◦
Remove Flex-10 iSCSI network connections using the -remove iscsi-connection
command.
NOTE:
You can remove all the iSCSI connections. You cannot add more connections than
the maximum allowed. The maximum allowed connections is based on VC firmware mode.
See the
for more information.
•
Select from the following FC connection options:
Add FC SAN connections using the -add fc-connection command.
◦
◦
Modify FC SAN connections using the -set fc-connectioncommand.
◦
Remove FC SAN connections using the -remove fc-connection command.
NOTE:
You can remove all the FC connections. You cannot add more connections than the
maximum allowed.
•
Edit the Fibre Channel boot parameters using the -set fc-connection command.
•
Select from the following FCoE connection options:
Add FCoE connections via the -add FCoE-connection command.
◦
◦
Modify FCoE connections via the -set FCoE-connection command.
◦
Remove FCoE connections via the -remove FCoE-connection command.
•
Edit the FCoE boot parameters via the -set FCoE-connection command.
•
Select from the following iSCSI boot parameters options:
Add iSCSI boot parameters using the –set iscsi-boot-param command.
◦
◦
Modify iSCSI boot parameters using the –set iscsi-boot-param command.
◦
Remove iSCSI boot parameters via the -remove iscsi-boot-param command. You
can’t add more than two boot parameters on the iSCSI connection.
NOTE:
You cannot add more than two boot parameters on the iSCSI connection.
•
Change the profile’s bay assignment via the –unassign profile and –assign profile
commands.
14
Using VCEMCLI