HP Insight Management-Software - Manual (Page 34)

set fc-connection
The -set fc-connection command modifies an existing FC connection to a server profile.
Syntax
-set fc-connection –profilename
-portnumber
[-fabric ]
[-speed ]
[–bootpriority ]
[–bootport ]
[–bootlun ]
Parameters
Table 12 Parameter descriptions for -set fc-connection
Optional Required Description Parameter
x The name of the server
profile that contains the
connection to modify -profilename
x The port number of the
connection being modified. -portnumber
x The name of an existing
fabric to associate with the -fabric
connection. If the fabric
name is not specified, then
the connection will be
marked as Unassigned
but associated with a
specific bay.
x The port speed of the
connection port. Valid values -speed
include auto, 1Gb, 2Gb,
4Gb
, 8Gb and disabled.
The default port speed is
auto
.
NOTE: For HP 4Gb VC-FC
Modules or HP Virtual
Connect 4Gb FC Modules,
supported speed values
include: auto, 1Gb, 2Gb,
4Gb
, and disabled. If it is
set to 8Gb, the speed is
auto-negotiated by VC.
x Controls whether the FC
HBA port is enabled for -bootpriority
SAN boot and affects the
BIOS boot order. Valid
values include the following:
•
Usebios
•
primary
•
secondary
•
disabled
Only one boot parameter is
allowed per FC connection.
34 Using VCEM commands