HP ProLiant WS460c G6 Workstation-Blade User Manual

Page 19

Text mode
Original mode

Operations 19

If you are removing the graphics card from the PCIe card cage, disconnect the power cables from the
graphics board.

Remove the two Torx-15 screws that secure the front of the PCIe card cage (1).

Carefully pull up on the front and right sides of the PCIe card cage to disengage it from the anchoring
pins on the expansion blade enclosure, and then lift the PCIe card cage out of the expansion blade

enclosure (2).

Configure the WS460c Graphics Expansion Blade
configuration with HBA

NOTE:

This unique configuration is for users who want to use a single mezzanine card with the

graphics expansion blade. (For example, using a HBA to connect to storage.) This configuration

permits the use of only one PCIe slot on the graphics expansion blade.