HP ProLiant WS460c G6 Workstation-Blade - Manual (Page 18)

Operations 18
4. To remove the graphics expansion blade from the workstation blade, carefully pull up on the front and
right sides of the PCIe card cage to disengage it from the anchoring pins on the expansion blade
enclosure (1), and then lift the PCIe card cage out of the expansion blade enclosure (2).
To reinstall the blade, follow these steps in reverse order.
Remove the WS460c Graphics Expansion Blade PCIe
card cage
To install another graphics card, you must remove the PCIe card cage from the WS460c Graphics Expansion
Blade. To remove the card cage:
1. Remove the WS460c Graphics Expansion Blade access panel (on page 17 ).
2. Disconnect the four PCIe/SAS cables from the PCIe riser board, noting the location for reinstallation.