HP ProLiant WS460c G6 Workstation-Blade - Manual (Page 17)

Operations 17
Remove the WS460c Graphics Expansion Blade
access panel
To remove the access panel:
1. Lift the access panel latch (1). The access panel slides to the rear (2).
2. Remove the access panel.
To reinstall the access panel, follow these steps in reverse order.
Remove the WS460c Graphics Expansion Blade
To remove the blade:
1. Remove the WS460c Graphics Expansion Blade access panel (on page 17 ).
2. Disconnect the four PCIe/SAS cables from the PCIe riser board, noting the location for reinstallation.
3. Remove the two Torx-15 screws that secure the graphics expansion blade to the workstation blade (1).