HP Deskjet F4185 All-in-One Printer - Manual (Page 112)

unplug the power cord, and use a soft cloth to wipe the glass and the back of the
document lid.
For more information, see:
• Clean the lid backing
• Clean the glass
The printout is blank
Cause: The original is placed incorrectly on the glass.
Solution: Place your original print side down on the left front corner of the glass.
Cause: The print cartridges need to be cleaned or might be out of ink.
Solution: Check the estimated ink levels remaining in the print cartridges. If the
print cartridges are low or out of ink, you might need to replace the print cartridges.
If there is ink remaining in the print cartridges, but you are still noticing a problem,
print a self-test report to determine if there is a problem with the print cartridges. If the
self-test report shows a problem, clean the print cartridges. If the problem persists,
you might need to replace the print cartridges.
For more information on print cartridges, see
Print cartridge troubleshooting .
A borderless copy has white space around the edges
Cause: You are trying to make a borderless copy of a very small original.
Solution: When you make a borderless copy of a very small original, the HP All-in-
One enlarges the original up to a maximum percentage. This might leave white space
around the edges. (The maximum percentage varies by model.)
Depending on the size of the borderless copy you are trying to make, the minimum
size of the original varies. For example, you cannot enlarge a passport photo to create
a letter-size borderless copy.
Chapter 12
110 Troubleshooting
T
roub
les
hoot
ing