HP Digital Sender Flow 8500 fn1 Document Capture Workstation series - Manual (Page 39)

6. When all access control security settings are complete, click Apply.
7. Select a file erase mode for erasing temporary job files.
a. Click the Security tab, and then click Protect Stored Data.
b. Under Managing Temporary Job Files, select the method for erasing temporary job
files, and then click Apply.
1. Open the Embedded Web Server.
2. Click the Security tab, and then click General Security.
3. Type a new password and then type the password again to verify.
4. Select Enable Host USB plug and play if you wish to enable the covered USB port on the
front of the product.
5. Click Apply.
Additional configuration using the Embedded Web
Server
The following table identifies configuration options available from the Embedded Web Server (EWS).
For information about specific options, see the EWS Help.
Table 3-7 Embedded Web Server configuration options
EWS tab Options
Scan/Digital Send Address Book, E-mail Setup, Save to Network
Folder Setup, Save to USB Setup, OXPd: Workflow,
Digital Sending Software Setup
Fax Fax Send Setup, Speed Dials
Networking ● Configuration (TCP/IP Settings, Network
Settings, Select Language)
● Security (Settings, Authorization, Management
Protocols, 802.1X Authentication, IP/Sec
Firewall)
● Diagnostics (Network Statistics, Protocol Info,
Configuration Page)
ENWW Additional configuration using the Embedded Web Server 31