HP Digital Sender Flow 8500 fn1 Document Capture Workstation series - Manual (Page 36)

3. Type the new password in the Password box and in the Confirm Password box.
4. At the bottom of the window, click the Apply button to save the password.
NOTE: You can also set a local administrator password from the General Security option on the
Security tab. When set, you must enter this password to change settings within the Embedded Web
Server.
Configure e-mail options
1. Open the Embedded Web Server.
2. Click the Scan/Digital Send tab.
3. In the left navigation pane, click the E-mail Setup entry.
4. Select Enable Send to E-mail and click Add, follow the SMTP wizard to complete the required
fields and any additional fields you want, and then click the Apply button.
TIP: You must specify an outgoing SMTP server and complete the From: field. See the
Embedded Web Server Help for more information.
5. To add addresses to the Address book, click the Address Book entry in the left navigation pane
and then follow the onscreen instructions.
After you have configured the e-mail settings, send an e-mail to yourself by using the digital-send
feature. If you receive the e-mail, you have successfully configured the digital-sending feature.
If you do not receive the e-mail, use these actions to resolve issues:
● Check the SMTP and address to make sure that you typed them correctly.
● View the configuration page. Verify that the SMTP gateway address is correct.
● Make sure that the network is operating correctly. Send an e-mail to yourself from a computer. If
you receive the e-mail, the network is operating correctly. If you do not receive the e-mail, contact
your network administrator or Internet service provider (ISP).
Save to Network Folder Setup
Before configuring network folders, set up shared folders following the instructions for your network
operating system.
1. Open the Embedded Web Server.
2. Click the Scan/Digital Send tab.
3. On the left navigation menu, click the Save to Network Folder Setup entry.
4. Select the Enable Save to Network Folder checkbox.
NOTE: If you select Use credentials of user to connect after Sign In at the control
panel in the Authentication Settings drop-down list, the logged-in user must have permissions
to write to the specified network folder.
5. Set the default settings you want for all folders and then click the Apply button.
6. To specify network folders to which to save documents, click the Add button in the Quick Sets
area and follow the onscreen instructions.
28 Chapter 3 Administration - Configure the product ENWW