HP Digital Sender Flow 8500 fn1 Document Capture Workstation series - Manual (Page 26)

Table 3-6 Jetdirect menus (continued)
Menu item Sub-menu item Sub-menu item Values and Description
IPV4 Settings Config Method Specifies the method that TCP/IPv4 parameters will be
configured on the HP Jetdirect server.
Bootp : Use BOOTP (Bootstrap Protocol) for automatic
configuration from a BOOTP server.
DHCP : Use DHCP (Dynamic Host Configuration
Protocol) for automatic configuration from a DHCPv4
server. If selected and a DHCP lease exists,
DHCP
Release and DHCP Renew menus are available to set
DHCP lease options.
Auto IP : Use automatic link-local IPv4 addressing. An
address in the form 169.254.x.x is assigned
automatically.
Manual : Use the Manual Settings menu to configure
TCP/IPv4 parameters.
Default IP Specify the IP address to default to when the Jetdirect
server is unable to obtain an IP address from the
network during a forced TCP/IP reconfiguration (for
example, when manually configured to use BOOTP or
DHCP).
Auto IP : A link-local IP address 169.254.x.x is set.
Legacy : The address 192.0.0.192 is set, consistent
with older HP Jetdirect products.
DHCP Release This menu appears if the Config Method item was set
to the DHCP value and a DHCP lease for the Jetdirect
server exists.
Yes : The current DHCP lease and the leased IP
address are released.
No (default): The current DHCP lease is saved.
DHCP Renew This menu appears if the Config Method item was set
to the DHCP value and a DHCP lease for the Jetdirect
server exists.
Yes : The Jetdirect server requests to renew the current
DHCP lease.
No (default): The Jetdirect server does not request to
renew the DHCP lease.
18 Chapter 3 Administration - Configure the product ENWW