HP ProLiant SL270s Gen8 SE Server - Manual (Page 66)

Hardware options installation 66
7. Install the TPM board. Press down on the connector to seat the board (" System board components " on
page 10 ).
8. Install the TPM security rivet by pressing the rivet firmly into the system board.
9. Install the GPU cage (on page 23 )
10. Install the SFF hot-plug drive cage (" Install the hot-plug SFF drive cage " on page 17 ).
11. Install the shipping brackets and shipping plates (on page 19 ).
12. Install the server into the chassis (" Installing the server into the chassis " on page 31 ).
13. Connect the peripheral cables.
14. Power up the server (on page 15 ).
Retaining the recovery key/password
The recovery key/password is generated during BitLocker™ setup, and can be saved and printed after
BitLocker™ is enabled. When using BitLocker™, always retain the recovery key/password. The recovery
key/password is required to enter Recovery Mode after BitLocker™ detects a possible compromise of system
integrity.