HP ProLiant SL270s Gen8 SE Server - Manual (Page 64)

Hardware options installation 64
8. Install the DIMM.
9. Install the processor air baffle (on page 25 ).
10. Install the GPU cage (on page 23 )
11. Install the SFF hot-plug drive cage (" Install the hot-plug SFF drive cage " on page 17 ).
12. Install the shipping brackets and shipping plates (on page 19 ).
13. Install the server into the chassis (" Installing the server into the chassis " on page 31 ).
14. Power up the server (on page 15 ).
After installing the DIMMs, to configure memory protection mode, use RBSU (" HP ROM-Based Setup Utility "
on page 79 ).
HP Trusted Platform Module option
For more information about product features, specifications, options, configurations, and compatibility, see
the product QuickSpecs on the HP Product Bulletin website ( http://www.hp.com/go/productbulletin ).
Use these instructions to install and enable a TPM on a supported server. This procedure includes three
sections:
1. Installing the Trusted Platform Module board.
2. Retaining the recovery key/password (on page 66 ).
3. Enabling the Trusted Platform Module (on page 67 ).
Enabling the TPM requires accessing RBSU. For more information about RBSU, see the HP website
(
http://www.hp.com/support/rbsu ).
TPM installation requires the use of drive encryption technology, such as the Microsoft Windows BitLocker
Drive Encryption feature. For more information on BitLocker, see the Microsoft website
( http://www.microsoft.com ).
CAUTION: Always observe the guidelines in this document. Failure to follow these guidelines
can cause hardware damage or halt data access.
When installing or replacing a TPM, observe the following guidelines: