HP Storage Mirroring Software - Manual (Page 70)

68 of 118
By default, charts display the legend if there is enough space to display it without
significantly affecting the size of the report. You can modify this behavior either to always
or never display the legend.
The Legend Settings determine whether to display or hide the legend. If set to
Automatic, the legend is displayed if the number of series is less than twelve.
To specify when to display the legend:
1. Click Legend Settings icon. The Legend Settings dialog box appears.
2. In the Show legend field, specify when the legend should be displayed.
3. In the Legend Position field, select where you would like the legend to appear on
the chart.
4. Click OK. The option is applied to the report in the report display area.
Series
All chart-based reports provide the ability to select which series are displayed in the
report. By default, when a chart is displayed, all series in the data set are displayed. You
can modify this behavior to only display certain series using the Series parameter.
To modify the series selection:
1. Click the Chart Data icon. The Series Editor appears.