HP StorageWorks XP Remote Web Console Software - Manual (Page 80)

80 Performance Control Export Tool
Limitations for storage partition administrators
If the user type of your user ID is storage partition administrator, you can use only Auto LUN XP and the
Export Tool among Auto LUN XP programs. In this case, you cannot use Volume Migration nor Server
Priority Manager.
Also, when you log in as a storage partition administrator, the available functions of Auto LUN XP and the
Export Tool are limited. This section explains these limitations of Auto LUN XP and the Export Tool.
Some file exists in path.
What do you do? clear(c)/update(u)/stop(p)
You selected “action”. Is it OK? (y/n)
Files exist in path.
• If you want to clear the files, press the c key.
• If you want to overwrite the files, press the u key.
• If you want to stop the operation, press the p key.
When you press a key, a message appears and asks
whether to perform the specified action.
• To perform the specified action, press the y key.
• To cancel the specified action, press the n key.
Specify the following subcommand before login
subcommand: retry
The retry subcommand is written in an incorrect
position in the command file.
Write the retry subcommand before the login
subcommand.
Start gathering group data
Target = xxx, Total = yyy
End gathering group data
The Export Tool starts collecting data specified by the
group
subcommand.
The number of targets is xxx and the total number is
yyy
(see Note below).
The Export Tool ends collecting data.
NOTE: For example, suppose that the disk array
contains 100 parity groups and the command file
contains the following command line:
group PG 1-1:1-2
The Export Tool displays the message "Target=2,
Total=100"
, which means that the group
subcommand specifies two parity groups and that the
total number of parity groups in the disk array is 100.
Syntax error: "line" A syntax error is detected in a command line in your
command file. Check the command line for the syntax
error and then correct the script.
Note that some operands must be enclosed by double
quotation marks ("). Please check the command line to
find whether double quotation marks are missing.
Table 27 Messages to be issued by the Export Tool (continued)
Possible problems Probable causes and recommended action