HP StorageWorks XP10000 Disk Array - Manual (Page 80)

80
6. Click the Close button.
The List Objects-Migration Groups subwindow redisplays with your modifications.
UTF-8 Encoding
For Name and Description, the number of entered characters is limited by the specified number of bytes
in UTF-8 encoding. In UTF-8, ASCII characters are 1 byte and non-ASCII characters are from 1 to 3
bytes.
10-4 Adding a Volume to a Migration Group
You can add a volume to a migration group. There is no restriction on the number of volumes you can add.
However, you cannot add a volume to a migration group that
You cannot add a volume to a migration group if:
• It is registered in an unfinished (the status is not Success, Failure, or Cancel) migration task. Wait
until the migration task finishes, and then add the volume.
• You have registered the volume in another migration group.
• You have registered a migration task whose target is the migration group to which you are adding the
volume.
To add a volume to a migration group:
1. From the navigation frame, select the Migration Group object.
The information frame displays the List Objects-Migration Groups subwindow.
2. From Name in the List Objects-Migration Groups subwindow, select the Migration Group Name to which
you are adding the volume.
The Migration Group Detailed Information-Migration Group Name pop-up window displays, as shown in
Figure 10-4.
Figure 10-4 Migration Group Detailed Information-Migration Group Name Pop-up Window
3. Click the Add Volume button.
The Add Volume-Migration Group Name pop-up window displays, as shown in Figure 10-5. (It does not
display if the status of a migration task is active or standby.)
Managin
g Migration Gro
u
ps