HP StorageWorks XP10000 Disk Array - Manual (Page 61)

61
Figure 7-5 Migrate-Step 2 of 4 Pop-up Window
After Tiered Storage Manager selects, from the selected migration target storage tier, a candidate
migration target volume corresponding to each volume in the migration group, the Migrate Step 2 of 4
pop-up window displays a list of volume pairs. This list allows you to modify the migration target volumes.
If you do not have to modify the migration target volumes, go to step 10.
5. Click the Modify button displayed to the left next of the desired migration target volume, and then modify
the migration target volume.
The Modify Volume Pair pop-up window displays for the volume pair containing the migration target
volume you are changing. In the Modify Volume Pair pop-up window, information on the migration source
volume (such as an LDEV) and a list of migration-target candidate volumes display, as shown in Figure 7-
6 below.
Figure 7-6 Modify Volume Pair Pop-up Window
You can use the following buttons on the Modify Volume Pair window:
Save and Continue: Saves the modification and allows you to modify another migration target
volume.
Save and Close: Saves the modification and returns to the Migrate-Step 2 of 4 pop-up window.
Close: Returns to the Migrate-Step 2 of 4 pop-up window without saving the modification.
6. Select a volume from the list of candidate migration target volumes.
Select the radio button to select the desired volume:
Performing a
Migration