HP XC System 3.x Software - Manual (Page 86)

confirm an expected high load on the nodes. The following is an example of this; the LSF JOBID is 200 and
the SLURM JOBID is 250:
$ srun --jobid=250 uptime
If you are concerned about allocating the resources too long or leaving them allocated long after you finished
using them, you could submit a simple sleep job to limit the allocation time, as follows:
$ bsub -n4 -ext "SLURM[nodes=4]" -o %J.out sleep 300
Job <125> is submitted to the default queue .
After you confirm that this job is running using the bjobs -l 125 command, you can operate interactively
for with the resources. If LSF-HPC observes no SLURM activity within the allocation after 5 minutes, it terminates
the job. Any existing SLURM activity (including running MPI jobs with the mpirun -srun command) is
allowed to continue.
LSF-HPC Equivalents of SLURM srun Options
Table 9-2 describes the srun options and lists their LSF-HPC equivalents.
86 Using LSF