HP XC System 3.x Software - Manual (Page 57)

Exiting TotalView
It is important that you make sure your job has completed before exiting TotalView. This may require that
you wait a few seconds from the time your job has completed until srun has completely exited.
If you exit TotalView before your job is completed, use the squeue command to ensure that your job is not
still on the system.
$ squeue
If it is still there, use the following command to remove all of your jobs:
$ scancel --user username
If you desire to cancel just certain jobs, refer to the scancel manpage for information about selective job
cancellation.
DDT 57