HP XC System 3.x Software - Manual (Page 52)

program should pick up the SLURM_JOBID environment variable. The SLURM_JOBID has the information
LSF-HPC needs to run the job on the nodes required by your preexecution program.
The following items provide the information you need to run the preexecution program on the resource
manager node, on the first allocated node, or on all the allocated nodes:
Table 5-1
This is the default behavior. Run the pre-execution program
normally.
Your preexecution does not need to make use of the SLURM_JOBID
environment variable.
To run a preexecution program on the resource manager node:
Use the SLURM srun -N 1 command. For example:
$ /opt/hptc/bin/srun -N 1 my_pre_exec
To run a preexecution program on the first allocated node:
Use the SLURM srun directly without node options. For example:
$ /opt/hptc/bin/srun my_pre_exec
To run a preexecution program on all allocated nodes:
NOTE Do not use the srun -b command (for SLURM batch mode) inside preexecution programs. The
srun -b
command returns immediately after a SLURM batch job is submitted. This can cause the preexecution
program to exit with success while the real task is still running in batch mode.
See the SLURM srun(1) manpage for more information about the srun command, its options, and the
SLURM_JOBID
environment variable.
52 Submitting Jobs