HP ProLiant ML350 G5 Server - Manual (Page 51)

Hardware options installation 51
7. Close the expansion slot latch to secure the board.
8. Connect any required internal cables to the expansion board. Refer to the documentation that ships
with the expansion board.
9. Install the expansion board retainer.
10. Install the access panel (on page 20 ).
11. Do one of the following:
o Close or install the tower bezel, as needed.
o Slide the server back into the rack.
12. Connect any required external cables to the expansion board. Refer to the documentation that ships
with the expansion board.
Parallel and second serial connector option
To install the component:
1. Power down the server (on page 17 ).
2. Do one of the following:
o Open or remove the tower bezel, as needed (" Open or remove the tower bezel " on page 18 ).
o Extend the server from the rack (on page 17 ).
3. Remove the access panel (on page 19 ).
4. Remove an expansion slot cover (" Removing the expansion slot cover " on page 48 ).
5. Install the parallel and serial connector bracket and close the slot cover.
6. Connect the parallel and serial cables to the parallel and serial connectors on the system board.
7. Install the access panel (on page 20 ).
8. Do one of the following:
o Close or install the tower bezel, as needed.
o Slide the server back into the rack.
9. Power up the server (on page 17 ).