HP ProLiant ML350 G5 Server - Manual (Page 45)

Hardware options installation 45
1. Install the full-height media device (" Installing a half-height or full-height media device " on page 42 ).
2. Remove the front guide screw from the full-height media device, and the silver shipping screw from
the chassis.
3. Install the silver shipping screw into the full-height device.
Installing a diskette drive
1. Power down the server (on page 17 ).
2. Do one of the following:
o Open or remove the tower bezel, as needed (" Open or remove the tower bezel " on page 18 ).
o Extend the server from the rack (on page 17 ).
3. Remove the media bay blank (" Accessing the removable media cage " on page 40 ).
4. Remove the access panel (on page 19 ).
5. Use a T-15 Torx screwdriver to remove the four 6-32 screws from the media bay blank.