HP LaserJet 9000 Printer series - Manual (Page 184)

Appendix B Control panel menus 184
Configure device menu
Print quality submenu
Some items in this menu are accessible from a software application, or from the printer driver (if the
appropriate driver is installed). Printer driver and software application settings override control panel settings.
For more information, see
“Using features in the printer driver” on page 51 .
Item Values Explanation
SET
REGISTRATION Shift the margin alignment to center the image on the page from top to bottom,
and left to right. You can also align the image on the front, with the image
printed on the back.
RESOLUTION=
FASTRES 1200 300
600
FASTRES 1200 Select the resolution from the values listed below:
300 : Produces draft print quality at maximum printer speed (50 ppm). 300 dpi
(dots per inch) is recommended for some bitmapped fonts and graphics, and for
compatibility with the HP LaserJet III family of printers.
600 : Produces high print quality at maximum printer speed (50 ppm).
FASTRES 1200 : Produces optimum print quality (comparable to 1,200 dpi) at
maximum printer speed (50 ppm).
Note
It is best to change the resolution from the printer driver or software application.
(Driver and software settings override control panel settings.)
RET=MEDIUM OFF
LIGHT
MEDIUM
DARK Use printer Resolution Enhancement technology (REt) setting to produce print
with smooth angles, curves, and edges.
All print resolutions, including FastRes 1,200, benefit from REt.
Note
It is best to change the REt setting from the printer driver or software
application. (Driver and software settings override control panel settings.)