Modifying an existing configuration, Choices available after opening acu – HP StorageWorks 1500cs Modular Smart Array User Manual
Page 19
Modifying an existing configuration 19
Modifying an existing configuration
In this section
Choices available after opening ACU....................................................................................................... 19
Modifying a configuration using Standard Configuration mode ................................................................... 19
Modifying a configuration using Express mode.......................................................................................... 20
Modifying a configuration using the Configuration wizards......................................................................... 20
Choices available after opening ACU
Open ACU as described in "Getting started (on page
At this point, you can continue operating in Standard mode, or you can select a wizard from the lower
right-hand panel. If the controller that you selected is an MSA1000, another link in this panel leads to a
screen that enables you to configure switches.
Modifying a configuration using Standard Configuration
mode
1.
Click an item in the Configuration View panel. The right side of the screen displays a list of the tasks
that are available for that item.
The tasks listed for the item are a subset of the total number of tasks that are possible for the selected
item. Which of the possible tasks are listed for an item and which are omitted depends on the
controller model and configuration. (For example, if the selected controller has no unassigned
physical drives, Create Array is not an available task.) The table ("
) lists all the possible tasks for every type of item.
2.
Click a task link. A list of all possible configuration options for that task appears on the right side of
the screen, replacing the task list.
3.
Set the configuration options the way that you want them to be.
4.
Click OK.