HP StorageWorks 1500cs Modular Smart Array - Manual (Page 13)

Configuring a new controller 13
Configuring a new controller
In this section
Using Standard Configuration mode......................................................................................................... 13
Using Express Configuration mode........................................................................................................... 14
Using the configuration wizards............................................................................................................... 15
Using Standard Configuration mode
1. Click an item in the Configuration View panel. The right side of the screen displays a list of the tasks
that are available for that item.
The tasks listed for the item are a subset of the total number of tasks that are possible for the selected
item. Which of the possible tasks are listed for an item and which are omitted depends on the
controller model and configuration. (For example, if the selected controller has no unassigned
physical drives, Create Array is not an available task.) The table ("
Possible tasks in Standard
Configuration mode " on page 13 ) lists all the possible tasks for every type of item.
2. Click a task link. A list of all possible configuration options for that task appears on the right side of
the screen, replacing the task list.
3. Set the configuration options the way that you want them to be.
4. Click OK.
Possible tasks in Standard Configuration mode
Menu item Possible tasks
Controller Controller Settings
Redundancy Settings (not available on all controller models)
Logical Drive Array Accelerator Settings
Create Array
Selective Storage Presentation (for MSA1000 and Smart
Array Cluster Storage controllers)
Clear Configuration
More Information
Advanced Features (not available on all controller models)