HP Integrity NonStop J-Series - Manual (Page 185)

System Management
HP NonStop AutoTMF Software User’s Guide—429952-016
A-11
HIGHPIN Attribute
HIGHPIN Attribute
In order for a process to be run in a high pin (process number > 255), both the program
object file and the user library file must have the HIGHPIN attribute set to ON. If either
one is OFF, the process will occupy a low pin. The AutoTMF user library files are
distributed with HIGHPIN ON. If you bind ESCRUNTM or link ESCRUNN or
ESCRUNNL with another user library, the resulting user library loses the HIGHPIN
attribute.

To set the HIGHPIN attribute for a TNS user library, use a Binder command, as
follows:

To set the HIGHPIN attribute for TNS/R library file, use the NLD command as
follows:
Hard-Coding Monitor Name into the Runtime
You can hard-code the monitor name into the NonStop AutoTMF runtime. This method
adds the special procedure ESCORT_MONITOR_NAME into the AutoTMF runtime.
Note that this method cannot be used for TNS/E native programs because the
AutoTMF product subvolume does not contain a linkable version of the AutoTMF DLL.
1. Create a source file with the following entries and assign the name of the alternate
monitor to the monname variable ($ZTST in this example):
2. Compile the source file using the appropriate compiler for each type of object file in
your environment:
BIND CHANGE HIGHPIN ON IN myuserlb
nld -change highpin on mynatlbt
nld -change highpin on mynatlbc
proc ESCORT_MONITOR_NAME( monname:len );
-- -------------------
string .ext monname;
int len;
begin
monname ':=' "$ZTST";
end; -- ESCORT_MONITOR_NAME
TAL /IN mnames/mnameo;SYMBOLS,SUPPRESS
PTAL /IN mnames/mnamen;SYMBOLS,SUPPRESS,SRL