HP Integrity NonStop J-Series - Manual (Page 157)

NonStop AutoTMF Commands
HP NonStop AutoTMF Software User’s Guide—429952-016
6-81
START MONITOR
START MONITOR
Starts a AutoTMF monitor process for one MapDB or all MapDBs.
process
the name of the AutoTMF monitor process to launch.
mapdb-subvol
the MapDB subvolume. This is an alternative method to specify the process to be
started.
If the parameter is omitted, the default monitor is assumed, most commonly
$ZESC. Use the
ENV command to display the current default monitor and MapDB.
option
BACKUP 0-to-15
the cpu number of the backup monitor process.
HOMETERM file-name
the home terminal for the monitor process.
If omitted, the home terminal is set to the default EMS collector. The default
EMS collector is $0, or the EMS collector configured by setting the global
parameter EMSCOLLECTOR.
Note that internally, the default hometerm of the monitor is $ZHOME, as
displayed by the TACL command STATUS $<process-name>, because an
EMS collector cannot be specified as the hometerm of a process when the
process is launched. Functionally however, the home terminal for the monitor
process is the default EMS collector, as shown by the AutoTMF
STATUS
MONITOR command.
PRIMARY 0-to-15
the cpu number of the primary monitor process.
PRIORITY 1-to-199
START MONITOR [ process | mapdb-subvol ] [, option ];
option is:
{ BACKUP 0-to-15 }
{ }
{ HOMETERM file-name }
{ }
{ PRIMARY 0-to-15 }
{ }
{ PRIORITY 1-to-199 }