beautypg.com

HP Integrity NonStop J-Series User Manual

Page 114

background image

NonStop AutoTMF Commands

HP NonStop AutoTMF Software User’s Guide429952-016

6-38

ALTER GLOBAL

NORMAL isolation commits outstanding transactions whenever a process
sends a request to another process.

STRONG isolation commits outstanding transactions whenever the
process does one of the following:

issues a READ or a WRITE to a device

issues a WRITE to a non-audited disk file

ISOLATION can also be set for selected programs using the

ADD

ATMFPROGRAMS

command.

ATMFMAXTIME 1-to-n-seconds

commits automatic transactions after n seconds, if the process is not holding
locks on any of the participating records. This is an advisory setting for
performance, not one that precisely controls management of automatic
transactions.

The value of n should be a power of 2 (1,2,4,8,16,32,...) in the range of 1 to
4096. If the value specified is not a power of 2, the value will be rounded to a
power of 2.

The default is 16 seconds.

MAXTIME can also be set for separate transactions and for selected programs.
See

ADD ATMFFILESET

and

ADD ATMFPROGRAMS

for details.

ATMFMAXTX 1-to-1000

the maximum number of concurrent transactions each prepared program can
process.

ATMFMAXTX is rounded up to the next multiple of 100 when AutoTMF opens
the TFILE ($TMP).

The default is 100.

If an application program opens the TFILE with a transaction depth greater
than 100, AutoTMF also increases its current value of MAXTX to the value
specified by the program, rounded up to the next multiple of 100.

An application program must open the TFILE before AutoTMF opens the
TFILE to have the maximum depth increased under program control. Once
AutoTMF has opened the TFILE, it cannot close and reopen the TFILE with the
desired depth.

In such cases, you must configure MAXTX specifically if a value larger than
100 is desired.

This manual is related to the following products: