Resetting iscsi connections – HP X1000 Network Storage Systems User Manual
Page 11
NOTE:
Any existing iSCSI connections must be reset before changes take effect.
Resetting iSCSI connections
If you use the Storage Networks dialog box to configure a preferred private storage network for iSCSI
traffic and there are one or more existing iSCSI connections on the system, the new setting will not
take effect until the existing connections are reset through iSCSI Initiator on the connected systems.
To reset an iSCSI connection:
1.
On the system that contains the iSCSI initiator whose connection has been changed, open
Microsoft iSCSI Initiator.
2.
On the Persistent Targets tab, select the iSCSI target that resides on your HP Storage System and
then click Remove.
3.
On the Targets tab, select the iSCSI target that resides on your HP Storage System and then click
Details.
4.
Select the target identifier from the list, click Log off, and then click OK.
5.
On the Discovery tab, under Target Portals select the IP address that was previously designated
for iSCSI traffic between the application server and the HP Storage System and click Remove.
6.
Click Add. In the IP address or DNS name field, type the IP address (IPv4) that was enabled for
iSCSI traffic in the Automated Storage Networks dialog box and then click OK.
7.
On the Targets tab, click Log On.
8.
Check the Automatically restore this connection when the system boots check box and then click
OK.
9.
Click OK to close the iSCSI Initiator Properties dialog box.
HP StorageWorks X1000 Automated Storage Manager
11