HP Lights-Out 100 Remote Management - Manual (Page 10)

Configuration 10
6. Press the down arrow (↓) key to scroll down and enter a valid IP address, subnet mask, and
gateway address (press the Tab key to move between address fields).
7. Press the down arrow (↓) key to scroll to the following settings, and set the parameters as needed
(the following example shows configuring for remote management processor access using telnet and
a Web page):
• BMC Telnet Service: [Enabled]
• BMC Ping Response: [Enabled]
• BMC HTTP Server: [Enabled]
8. Press the F10 key to save and exit.
Establishing user accounts
The remote management card supports an administrator and an operator account.
The default account is Administrator, which enables the user to execute the full set of CLP commands and
change management processor configuration. The default user name is admin, and the default password
is admin.
The operator account enables the user to execute common commands and functions but restricts access to
specific functions, such as adding and changing user account information and changing the configuration
of the management processor. HP recommends logging in with the operator account to perform common
functions. The default user name is Operator, and the default password is Operator.
For more information on how to log in to the remote management card, refer to the "Logging in to the
remote management processor (on page
18 )" section.