HP Integrity rx2800 i2 Server - Manual (Page 9)

Introduction 9
o tcl-8.x package
o expect-5.x package
• Starting with Linux PSP 8.40 and later, ensure the following platform-specific compatibility libraries are
also installed:
o For Red Hat Enterprise Linux 4x86 servers
— compat-libstdc++-296-2.96-132.7.2.i386 or later
— lm_sensors-2.8.7-2.i386 or later
— net-snmp-5.1.2-11.i386 or later
— perl (required to provide the libperl.so)
— libnl (required for QLogic and Emulex drivers)
o For Red Hat Enterprise Linux 4 AMD64/EM64T servers
— compat-libstdc++-296-2.96-132.7.2.i386 or later
— lm_sensors-2.8.7-2.x86_64 or later
— net-snmp-5.1.2-11.x86_64 or later
— perl (required to provide the libperl.so)
— libnl (required for QLogic and Emulex drivers)
o For Red Hat Enterprise Linux 5 x86 servers
— compat-libstdc++-2.96-2.96-132.7.2.i386 or later
— lm_sensors-2...7-2.i386 or later
— net-snmp-5.3.1-14.e15.i386 or later
— perl (required to provide the libperl.so)
— libnl (required for QLogic and Emulex drivers)
o For Red Hat Enterprise Linux 5 AMD64/EM64T servers
— compat-libstdc++-296-2.96-132.7.2.i386 or later
— lm_sensors-2.8.7-2.x86_64 or later
— net-snmp-5.3.1-14.e15.x86_64 or later
— perl (required to provide the libperl.so)
— libnl (required for QLogic and Emulex drivers)
o For Red Hat Enterprise Linux 6 servers
NOTE: The following versions listed are needed as a minimum. Later versions of these might be
used as well.
NOTE: Ensure that each NIC has an IP address assigned. To get the IP address assigned to a
NIC, enter the dhclient command in the console, which enables the NIC interfaces and
retrieves an IP address. If a NIC does not have an IP address, HP SUM appears to hang on start
up.
o RHEL6 console mode
NOTE: No X console in either x86 or x86_64 servers. To run HP SUM in silent mode, you must
install the base server with defaults and the following RPMs.