HP Integrity rx2800 i2 Server - Manual (Page 79)

Scripted deployment 79
Parameter Description Possible values
installation.
Do not use the /romonly parameter with the
/softwareonly parameter.
SOFTWAREONLY This parameter is a filter switch and allows the user
to view only the software components required for
installation.
Do not use the /softwareonly parameter with
the /romonly parameter.
YES, NO
USECURRENTCREDENTIAL This parameter enables the credentials of the local
host to be used as the credentials to access the
targets instead of providing the username and
password explicitly for each target.
The assumption is that the current credentials are
valid for the targets being accessed. (Applies to
Windows® operating systems only.)
YES, NO
WEBUPDATENEEDED This parameter enables you to instruct HP SUM to
include the components from the HP FTP site
( ftp://ftp.hp.com ) in the list of possible updates.
This parameter does not apply to Integrity Servers.
YES, NO
USEPROXYSERVER This parameter enables the inclusion of a proxy
server (and port number) to access the HP FTP site
(
ftp://ftp.hp.com ). This parameter does not apply
to Integrity Servers.
String value
For example,
11.22.33.44:80
USEPROXYSCRIPT This parameter enables the inclusion of a proxy
script to access the HP FTP site ( ftp://ftp.hp.com ).
This parameter does not apply to Integrity Servers.
Web URL (for example,
autoproxy.com)
DELETEINPUTFILE This parameter enables you to instruct HP SUM to
delete the input file after it has been read in. YES, NO (default)
ONFAILEDDEPENDENCY This parameter instructs HP SUM how to proceed
when a component has a failed dependency.
The default of OmitHost causes the host to be put
in a failure state and no install is attempted on it.
OmitComponent clears the affected components
and proceeds with any updates that do not have
dependency failures. Force attempts all updates,
even if they have dependency failures.
OmitHost (default),
OmitComponent, Force
HOST This parameter is the IP address or the DNS name
of a remote server, remote iLO NIC port, Virtual
Connect Ethernet or Fibre Channel Module for
c-Class BladeSystem, or BladeSystem Onboard
Administrator.
When two Onboard Administrators are in an
enclosure, this parameter is the active Onboard
Administrator. When specifying the IP address, you
can use either the IPv4 or IPv6 format.
This parameter specifies an already defined group
name in the HP SUM GUI.
IP address, DNS name
UID This parameter enables you to log in to the target
hosts with your user ID.
PWD This parameter enables you to use the password for
the user ID specified in the UID.
The password is used to log in to target hosts.
LOGFILENAME This parameter enables you to set the name of the
log file generated by HP SUM to something other
Log file name