HP Integrity NonStop H-Series - Manual (Page 147)

Troubleshooting
Mid-Range Library Media Manager Installation and User’s Guide — 541641-001
C -13
Example 2
Example 2
PROBLEM:
When I run the INTFACE Utility program, I receive a run-time error...
SOLUTION:
The most common reason for this is that the INTFACE Utility program does not know
where to find the PROCFILE file in the MLMM ISV location or that MLMM is not
started. You have to make sure the MLMM ISV location is included on the command
line and that the MLMM software is running. For example:
The 2nd parameter [$SYSTEM.OUTPUT.TAPELIST] can be any valid fully qualified
filename.
The 3rd parameter [$SYSTEM.TSIMLMMS] is the MLMM ISV location. There has
to be a file called PROCFILE in this subvolume. If there is not a PROCFILE file in
this subvolume, then MLMM is not started or you have an older version of MLMM,
before the INTFACE Utility program was supported.
RUN $SYSTEM.TSIMLMMS.INTFACE/name/ REPORT
$SYSTEM.OUTPUT.TAPELIST $SYSTEM.TSIMLMMS
Troubleshooting Examples for Miscellaneous
Problems
Example 1
PROBLEM:
Does the MLMM software perform some type of internal checking on the system
number of the node onto which the software is running?
SOLUTION:
The MLMM software is shipped with your system number hard coded into the software.
Within the configuration program, there is a place to set up an alternate system
number... [ CONFIG_ALTSYS# ] TO CONFIGURE ALTERNATE SYSTEM NUMBER.
During disaster recovery testing, this alternate system can be used for 15 days. In the
event of a true disaster, TSI would provide you with a new version of the MLMM
software to run on your new primary system.