Suggested action, Error occurs during data copy of linux migration, Cause – HP Insight Foundation Software for ProLiant User Manual
Page 63: Cause suggested action
Source Agent fails to launch when source server reboots in migration agent mode
Suggested action
Try the following:
1.
To return to the original configuration, reboot the source server to Profile 1 Hardware Profile.
2.
Remove server migration Source Agent Mode manually.
a.
Right-click My Computer, and then select Properties.
b.
Click the Hardware tab, and then select Hardware profiles.
c.
Select server migration Source Agent Mode, and then click Delete.
3.
Before you start a new migration, verify that all antivirus and firewall software is properly
reconfigured or disabled.
Error occurs during data copy of Linux migration
An Error during data copy offset=offset srcPos=source sector
dstPos=destination sector amount=number of sectors
message appears in the
source or destination log, followed by an I/O exception.
Cause
Bad blocks might exist on the source or destination disk.
Suggested action
Insight Control does not support migrations of disks that have bad blocks. If the bad block is on
the destination disk, change the destination disk.
SAN-connected destination server displays a blue screen
Suggested action
To migrate Windows Server 2003 to a SAN-connected destination server, install the following on
the source server:
•
Service Pack 1
•
Service Pack 2
•
Updated Storport storage driver (for more information, see
)
Out of memory
error occurs on the application station during migration
The Insight Control application station requires a minimum of 1024 MB of free memory for Insight
Control migrations.
Suggested action
Free memory or add memory to the application station, and then restart the migration.
Destination server boots with an invalid IP address
After a P2P migration, the destination server might boot with an invalid IP address (for example,
169.x.x.x), instead of using the IP address that was configured through the migration wizard.
Cause
This issue occurs if the destination IP address configuration fails or Dynamic Host Configuration
Protocol (DHCP) is not enabled in the network. Whenever a NIC is added to the server, by default
the NIC is assigned an IP address using the DHCP configuration. If no DHCP server is configured
on the network, the server will boot with an invalid IP address.
Migration process
63