HP Workstation xw8000 - Manual (Page 64)

3-32
Adaptec SCSI RAID 2120S/2200S Software User’s Guide
Controlling ARCPD for NetWare
To stop the ARCPD using NetWare, type unload arcpd.nlm
then unload notify.nlm.
To restart the ARCPD, type load arcpd.nlm then load
notify.nlm
.
Configuring the Notifier Service
To configure the notifier service:
1 Place your cursor at a command prompt in the directory where
Adaptec Storage Manager was installed.
2 Type any of the following commands:
■ For Windows: notify -c > Enter
■ For Unix/Linux: anotifyd -c > Enter
■ For Netware: load notify -c > Enter
System Event Log
The next step in configuring the notifier utility will ask you
whether or not controller events should be added to the system
event log. The default is set to log no events.
To add controller events:
1 Choose Y (yes).
2 Select which level(s) of events you want to log. The list of events
are found in
Table 3-3 . Each level of event can be enabled or
disabled independently. For example, press 1 to enable logging
of Critical events. Alternatively, to log both Critical and
Warning, press 1 then 2.
UG.book Page 32 Saturday, October 26, 2002 12:08 PM