Chapter 5: configuring the server, Proliant servers, Using rbsu – HP Integrity rx4640 Server User Manual
Page 38: Chapter 5, Configuring the server, Proliant servers -1, Using rbsu -1

5
Configuring the Server
ProLiant Servers
After installing the controller hardware and updating the firmware, configure the
server by using either RBSU or SCU. (A brief description of the procedure is given
in this section. For more information, refer to the HP ROM-Based Setup Utility User
Guide or the server setup and installation guide.)
Using RBSU
RBSU is a system configuration utility that is embedded in the system ROM. It is
customized for the server on which it is installed.
CAUTION: Not all servers support RBSU. Do not flash an RBSU-ROM image onto a
server that is already configured with SCU unless the update instructions specifically
state that upgrading from SCU to RBSU is supported. If the upgrade is not
supported, the consequences of upgrading are unpredictable, and you may lose
data.
To use RBSU:
1. Power up the server.
2. Press the F9 key when prompted during system startup.
The main RBSU screen is displayed.
3. Configure the system. (For more information, refer to the ROM-Based Setup
Utility User Guide.)
HP Smart Array 5300 Controller User Guide
5-1
HP CONFIDENTIAL
Writer: Kimberly Koch File Name: f-ch5 configuring the server.doc
Codename: SilverHammer Part Number: 135606-006 Last Saved On: 3/13/03 1:57 PM
- Integrity rx7620 Server Integrity rx8620 Server Integrity rx2660 Servers Integrity Superdome sx1000 Server Integrity Superdome sx2000 Server Integrity rx3600 Server Integrity rx2600 Servers Integrity rx8640 Server Integrity rx5670 Server Integrity rx7640 Server Integrity rx2620 Servers Integrity BL860c Server-Blade Integrity rx6600 Server Integrity rx1620 Servers