End of paper feed, Rel lever is in wrong position, Rewinding error – Canon imagePROGRAF iPF815 User Manual
Page 918: Media take-up unit ready, End of paper feed rel lever is in wrong position, Rewinding error media take-up unit ready
Cause
Corrective Action
The Cutter Unit stops in
the middle of cutting.
(See "Specifying the Cutting Method for Rolls.")
In other cases, the Cutter
Unit may be damaged.
Contact your Canon dealer for assistance.
End of paper feed.
Cause
Corrective Action
You are pressing the ▲ button on the Control Panel and trying to rewind the roll to the edge.
Release the ▲ button.
Paper can be retracted only up to 17 mm (0.7 in) when using the Media Take-up Unit.
Release the ▲ button.
Rel lever is in wrong position.
Cause
Corrective Action
The Release Lever is up.
Lower the Release Lever.
If the error occurs again, turn off the printer and wait a while before restoring power.
Rewinding error.
Cause
Corrective Action
There is some foreign object near the Media Take-up Unit sensor
and the roll cannot be detected.
Remove the foreign object near the sensor.
The Media Take-up Unit sensor is soiled and the roll cannot be de-
tected.
Wipe the sensor with a dry cloth to clean it.
The roll is out of range of detection by the Media Take-up Unit sen-
sor.
Reload the roll.
(See "Loading Rolls in the Printer.")
The Media Take-up Unit sensor is damaged.
Contact your Canon dealer for assistance.
A paper jam has occurred and the roll cannot be rewound.
Remove the paper from the Media Take-up Unit.
Press the Online button to clear the error.
*Printing will stop momentarily if an error involving the Media Take-up Unit occurs. If you prefer printing not to
stop, set Skip Take-Up Err to On.
Media take-up unit ready.
Cause
Corrective Action
The Take-up Reel setting in the printer MAIN MENU
was changed from Enable to Disable, but a print job was
received before the roll was removed.
Press the Stop button and stop printing.
The mode switches from take-up mode to regular mode af-
ter you change the Take-up Reel setting in the MAIN
MENU from Enable to Disable and lift the Release Lever,
or after you execute Paper Cutting.
Error Message
>
Messages regarding paper
>
End of paper feed.
iPF815
13
902