Brother HL-4070CDW - Manual (Page 52)

Installing the Printer Driver
50
STEP 2
Macintosh
®
Ma
ci
nt
osh
®
Wi
rel
es
s
Ne
two
rk
3
Choose Wireless Setup and Driver Install,
and then click Next.
4
Read the Important Notice and check the box
after you confirm this setting, and then click
Next.
5
Choose Manual and then click Next.
6
Choose I’m able to temporarily connect my
device to my access point with a network
cable and then click Next.
7
For configuration, you must temporarily
connect your Brother wireless device (your
printer) directly to a free port on your access
point, hub or router using a network cable.
When the following screen appears, insert the
network cable to the access point and then to
the printer. Click Next.
8
Choose the printer you wish to configure, and
click Next. If the list is blank, check if the
access point and the printer are powered on,
and then click Refresh.
Note
The default Node name is “
BRNxxxxxx” for the
users that temporarily connect with a network
cable, or “
BRWxxxxxx” for the users that connect
without a network cable (where “ xxxxxx” are the
last six digits of Ethernet address).
9
The wizard will search for wireless networks
available from your printer. Choose the access
point you wish to associate the printer with, and
then click Next.
Note
• "SETUP" is the default SSID of the printer. Do not
choose this SSID.