Brother PT-P750W - Manual (Page 10)

Printing from Computers
5
2
Establishing a Wireless Network Connection
2
This section describes how to configure the wireless network settings and establish a wireless network
connection, if you did not configure the wireless network settings during the installation.
Note
If the P-touch labeler is powered by alkaline or Ni-MH batteries, you cannot establish a wireless network
connection. Use the rechargeable Li-ion battery or the AC adapter.
Using WPS (Wi-Fi Protected Setup™)
2
If your WLAN access point/router supports WPS (Wi-Fi Protected Setup™), settings and connections can be
configured easily with the press of a button.
a First, confirm that your WLAN access point/router has the WPS symbol.
b Press and hold the Wireless Mode button on the P-touch labeler for more than 5 seconds.
After the Wi-Fi lamp starts flashing in 0.5 second intervals, release the button.
c Press the WPS button on your WLAN access point/router.
d
When the connection is established, the Wi-Fi lamp is lit.
Note
The printer will try to connect using WPS for 2 minutes. If the Wireless Mode button is pressed and held
for 5 seconds during that time, the printer will continue trying to connect for an additional 2 minutes starting
from that point.